After clicking OK, the opening window shows a bare board. To start, we will add our primary component which happens to be included in the devices selection. To add it to the board, start by clicking the devices icon.
Figure 9.2
The top tool bar adds a line of information about the device chosen. Click the drop down menu to see a list of devices available.
Figure 9.3
Select the ATMEGA 16 MCU as shown in figure 9.4.
Figure 9.4
When you move the mouse pointer over the blank board (the bluish square) you will see an outline of the Atmega hovering. Wherever you left click the mouse, it will drop a chip on the board.
Figure 9.5
If you drop too many on the board, click the arrow icon, then click the extra device. The device will be highlighted. Just press the delete key and it will erase whatever was highlighted. If you have a number of components you wish to erase, click and drag the mouse to create a box. Everything in the box will be highlighted.
Figure 9.6
You can also move the selected items around the board by clicking and holding on the item while you move the mouse around.
