BASCOM AVR Tutorial

Open the unzipped folder bcavrd 1 and click the setup icon. You may get a warning for the digital signature validation.

 

Figure 4.1

Click Run and proceed with the installation. The installation is just like installing any other software. You should allow the software to install in the default locations and settings it selects if possible.

When the installation begins, it will prompt you to insert disk #2. If you downloaded and unzipped the files as suggested in this manual, all you need to do is backspace over the 1 in the file location, DESKTOP/Desktop/bascom/bcavrd_1 and make it DESKTOP/Desktop/bascom/bcavrd_2 as shown in figure 4.2.

 

Figure 4.2

You will be prompted to insert the remaining disks through disk 6. Simply perform the same action of typing the new number in the Source Pathname as you did for disk 2 for all of the remaining prompts, typing 3 for disk 3, 4 for disk 4, etc.

After the software has been installed, it is a good idea to restart your computer. Most computers will not be adversely affected without a restart, but it is good practice to do so. When your computer is back up, go to start, all programs, BASCOM-AVR, and click on BASCOM-AVR. BASCOM will start up with an empty window.

 

Figure 4.3